In daily work, staff should pay attention to the following points in daily maintenance：

(1) Hydraulic system

     Check whether the oil level is normal before starting；

     Whether the proximity switch and limit device are fastened；

     Are manual and automatic cycles normal?；

     Is the solenoid valve in its original position?；

     Turn on the cooling water before turning it on, and drain the cooling water after turning it off.

(2) Mechanical system

     The molded cement color tile machine is filled with lubricating oil on the upper surface and inner surface of the workbench guide rail, the sliding surface of each guide column, the sliding surface around the upper mold and the liner, and the movement binding surface of the ejection mechanism before starting every day.；

     Whether the connection of each moving part is loose or not, if any loosening is found, tighten it.

(3) Pneumatic system

     Discharge the condensate from the air compressor and air filter before turning on and after turning off every day；

     When the pneumatic device is running, check whether the oil dripping volume of the oil mist device (2-3 drops per minute) is appropriate；

(4) During the entire operation of the molded cement color tile machine, pay attention to the operating conditions of each system and the quality of the brick billet at any time. If abnormalities are found, it should be stopped immediately and restarted after troubleshooting.

(5) If the filter cloth is found to be blocked or damaged, it must be rinsed or replaced in time to ensure the quality of the blank.

In summary, Dongchen manufacturers believe that as long as you strictly abide by the maintenance of the molded cement color tile machine and the above points, our molded cement color tile machine will definitely be like a tiger in your production and use, reaching its rightful production speed and service life, and adding branches and colors to your success.