With the development of mechanical brick and tile equipment, the requirements for brick making machine equipment are getting higher and higher, and the use of brick making machine equipment needs to be strengthened. How to repair the hollow brick machine?

⒈ When installing or replacing new or old molds, be sure to avoid collisions and bumps, assemble in a civilized manner, and pay attention to protect the molds;

⒉ Always check the size of the mold and the condition of the welding joint during use. If there is a crack in the weld, it should be repaired in time. If the wear is too fast, the aggregate size should be adjusted. If the wear and tear affects the quality of the product, a new mold should be provided;

3. Carefully adjust the gap, including the equal spacing between the indenter and the die core, the indenter and the moving plane of the feeder, the die frame and the wire plate, and the relative movement must not interfere or rub;

⒋When cleaning molds daily, use air compressors and soft tools to remove concrete residues, and it is strictly forbidden to beat or pry the molds with gravity;

⒌The replaced mold should be cleaned and oiled to prevent rust. It should be placed in a dry and flat place with support pads to prevent gravity deformation.

Summarize the three aspects that should be paid attention to when using Gaomi Dongchen hollow brick machine equipment.

        First, understand the principle of hollow brick machine equipment

        Different models, the working principle of the hollow brick machine equipment will be somewhat different. So, for this, we must understand clearly. For example, hollow bricks have light weight, high strength, good thermal insulation, sound insulation and noise reduction performance. Environmentally friendly and pollution-free, it is an ideal filling material for frame structure buildings. Then why it has these characteristics, this is what we need to understand.

        In the second aspect, Gaomi Dongchen hollow brick machine equipment mould

        The selection of hollow brick machine equipment mold is divided into the following points. In use, check the size of the hollow brick machine mold and the condition of the welding joints. If there is a crack in the weld, it should be repaired in time. If the wear is too fast, the aggregate size should be adjusted. If the wear is too much, it will affect the quality of the product. Press and soft tools to remove concrete residues, and it is strictly forbidden to hit or pry the mold with gravity; carefully adjust the gap of the hollow brick machine, including the indenter and the mold core, the indenter and the moving plane of the feeder, the mold frame and the wire plate, and the relative movement Do not interfere or touch; the replaced hollow brick machine mold should be cleaned and oiled to prevent rust. It should be placed in a dry and flat place and placed on a support pad to prevent gravity deformation.

        In the third aspect, the debugging of hollow brick machine equipment

        It is inevitable that the hollow brick machine equipment needs to be debugged in use. What should I pay attention to when debugging? Check whether the Gaomi Dongchen brick machine is damaged or deformed during transportation (especially the hydraulic pipeline). Check whether the fasteners in the main parts of the Gaomi Dongchen brick making machine are loose. Check the reducer. Whether the oil cylinder and each lubrication point of the vibration table are refueled as required, and whether the oil quantity is appropriate. In addition, the non-firing brick machine should be thoroughly wiped. Before the test machine, the relative sliding parts of each moving part should be lubricated according to the regulations. If the machine needs to be disassembled due to transportation, it can be divided into forming device, plate feeding device, feeding device, brick discharging device, stacking device, phase electric control device, etc., which should be assembled in place according to the assembly relationship during installation.